Cubietruck nas how to prank it up

This is another easy project I did on my weekend.

cubietruck nas how to prank it up

By silentbogo eprojects. Thank you for your attention and good luck! Signal Level: Separate Ground and Active wire so they won't touch, once attached to the motherboard. Almost anything even a bare piece of wire will do better than stock.

If you own an aftermarket Cubie case, you can just drill a 6-7mm hole where you want your antenna to be and go straight to assembly. Before mod: A cubietruck 'ible! Wait until it's done, assemble the case and attach the external antenna. List of tools: I'm sure this ible will come in real handy.

cubietruck nas how to prank it up

Thanks for sharing! Check the end result for any flaws, redo if necessary, but try not to damage the board, or solder points.

cubietruck nas how to prank it up

Warm up your soldering iron and take a close look at the top-right corner of your board. I Made It! Share it with us! I bought one not so long ago to act as a media centre hidden in an old record player. MsSweetSatisfaction 4 years ago on Introduction.

Cubietruck External WiFi Antenna

What an awesome hack, really cheap too if you have the parts just laying about. This nuisance can be fixed in less than 15 minutes, including the soldering iron warm up.

Split Flap Display - Antique Remix. If you ended up here, this can only mean that you are a Cubietruck owner and as every one of us you have really weak wifi signal. Reply Upvote. Make sure that it's sitting in place firmly, because you don't want it to move, once antenna is in place.

cubietruck nas how to prank it up

If you are not proficient with soldering small parts and even if you think you are , protect the surrounding areas with small pieces of thermal tape. More by the author: Did you make this project? In this project I am using a 7dBi omnidirectional antenna, because this is the only one laying around leftover item from 3pc set I bought for my other creation.